Topics Topics Edit Profile Profile Help/Instructions Help Member List Member List  
Search Last 1|3|7 Days Search Search Tree View Tree View  

Headstay - Check yours!

S2 9.1 Class Bulletin Board » Technical Assistance, Fixes & Advice » Headstay - Check yours! « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

William Shirley
New member
Username: William_shirley

Post Number: 3
Registered: 04-2002

Rating: N/A
Votes: 0 (Vote!)

Posted on Sunday, May 05, 2002 - 04:31 pm:   Edit PostDelete PostView Post/Check IPPrint Post   Move Post (Moderator/Admin Only)Ban Poster IP (Moderator/Admin only)

I have my rig down to get the rod, reheaded and a Harken Unit 1 put on. I noticed that the Headstay toggle was held in place by a pin, but that pin is held in place by the crown of two flathead screws., additionally, with the halyard guard in place, there is no way for the pin to come out. Are you talking about the pin and cotter key on the part of the headstay that attaches to the toggle I am talking about?

Thanks,
William Shirley
Top of pagePrevious messageNext messageBottom of page Link to this message

Mike Sheppard

Rating: 
Votes: 1 (Vote!)

Posted on Monday, March 06, 2006 - 07:00 pm:   Edit PostDelete PostView Post/Check IPPrint Post   Move Post (Moderator/Admin Only)Ban Poster IP (Moderator/Admin only)

While sailing the Verve Cup we almost lost our rig when the headstay suddenly failed dropping the jib and headstay to the deck, only quick reation by the crew to drop the main and run the jib haylard forward to the bow saved the rig.

Upon inspection we found that the cotter pin had worn away and over time the pin worked loose. The pin is covered by a u-shaped plate making inspection difficult. There is a design flaw that causes the cotter pin to rub between the turnbucle and the mast. Over time the cotter pin will wear. You can improve the situation by making sure the pin is pointing up and down minimizing contact area. It would be even better to put the pin on the outside, but that is almost impossible with the rig standing. So I would think this is a common problem for all the boats.

Please inspect your rig! We nearly had a disaster. If the waves had been a bit higher we would be looking for a new mast. The pin only cost $0.50 an an ounce of prevention would have saved us a race.

Good Luck!

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action:

Administration Administration Log Out Log Out   Previous Page Previous Page Next Page Next Page